Troubleshooting
Most surprises have a simple cause. Find the symptom below.
No sound comes out
- The activation panel is showing. Until LH-2044 is activated or its trial is running, it outputs silence, whatever the switches say. Activate it or start the trial (see Your licence and the free trial).
- The trial has ended. The panel says so. Enter a licence key to continue.
- The cut-off is very low. At 20 to 50 Hz most material is almost silent. Turn Cut-Off up.
- The output knob is turned right down. At -48 dB LH-2044 is nearly silent. The default is 0 dB.
The meter does not move
The meter is dark while the plugin is switched OFF, while LH-2044 is not activated, and when no audio reaches it. Check that the track is playing and that its input is reaching the plugin. A level below -48 dB does not light any LED.
The envelope never fires
- Attack is OFF. The readout shows OFF: turn it up.
- The threshold is above your signal. Lower Threshold until the hits fire it.
- The signal never gets quiet. The envelope only re-arms after 50 ms below the threshold. On a dense loop, a pad or a full mix, raise Threshold so that the gaps between hits count as quiet. See Threshold.
- The cut-off is already high. With Cut-Off near 20 kHz there is nowhere for the envelope to go. Bring it down.
The envelope fires on some hits but not others
Once fired, the envelope runs for about 305 ms before it can fire again, and it re-arms only after the input has been below the threshold for 50 ms. Hits that come faster than that, such as sixteenth-note hi-hats, share one envelope. That is often what you want: set the threshold so the hits you care about stand out.
I hear hiss
That is the analog noise floor, about -75 dBFS, and it is on by default. Turn it off with the Noise parameter in your host (see Host-only switches). It is also why an LH-2044 on a silent track still shows a tiny output level in your host.
It sounds distorted
- The output stage is driven. If the top LEDs are lit, the saturation is working. Turn the output knob down.
- The input is hot. The filter adds about 4 dB of makeup gain plus a bass lift. A signal peaking near 0 dBFS drives the output stage even at 0 dB. Turn the output knob down a few dB.
- Saturation is off and 12 BIT is on. Then anything over full scale clips hard. Turn the output knob down or switch Saturation back on.
- Grain on quiet sounds is the 12-bit reduction. Turn 12 BIT off if you don't want it.
LH-2044 is louder than bypass
The bass lift and makeup gain are part of the sound. To compare fairly, lower the output knob until the level matches the bypassed sound.
LH-2044 is not in my host
- Look in the effects list, not the instruments, under Low Hiss Systems.
- Ask your host to rescan its plugins. Some hosts only scan on start-up.
- Mac Logic Pro and GarageBand use the AU version; most other hosts use the VST3.
- Check that the track is mono or stereo. LH-2044 does not load on surround tracks.
Licence problems
- Key not recognised
- Copy it again from your order email, without spaces around it. Keys start with
LH-. - Too many devices
- A licence works on 2 devices. To move it to another one, go to your account on low-hiss.com or contact support.
- Trial unavailable
- The free trial isn't available for this device. means this computer has already had its trial. Send the Support ID shown on the panel to support if you think that is wrong.
- Offline
- Activation needs an internet connection once. If the panel later asks to check the licence, reconnect and press Refresh licence / I just upgraded.