The Output Stage
After the filter, LH-2044 runs your audio through the rest of the machine's output: an op-amp that saturates when pushed, a 12-bit converter and a faint analog hiss. Together they are what makes a clean filter sound like old hardware.
Output level and drive
The small knob in the top row sets the level going into the output stage, from -48 dB to +12 dB. At its default of 0 dB the level is unchanged. The meter beside it shows that level (see The meter).
Because the knob comes before the saturation, it doubles as a drive control:
- Turn it down to keep the output stage clean and lower the plugin's output.
- Turn it up to push the filtered signal into the op-amp's soft knee for warmth and density. The plugin gets louder only a little, then mostly thicker.
To drive harder without getting louder, turn the output knob up and the channel fader in your host down.
Saturation
LH-2044 models the op-amp that sat between the SP-1200's converter and its output jacks. Below about -7 dBFS it does nothing at all. Above that it bends the waveform smoothly and a little unevenly (positive and negative peaks are treated slightly differently, as in the real circuit), spreading the effect over a wide range of about 18 dB rather than slamming into a ceiling. Its output always stays just below full scale, so LH-2044 cannot clip digitally while saturation is on.
The saturator is anti-aliased: when driven hard it stays warm rather than turning harsh and brittle.
Saturation is on by default. It has no switch on the faceplate: you turn it off from your host, through the Saturation parameter (see Host-only switches). When it is off, the stage is skipped entirely and the output is bit-exact.
12-bit reduction
With 12 BIT lit, the output is rounded to 4,096 levels, the resolution of the SP-1200's converters. On loud material you mostly hear a slight hardening; on quiet passages, reverb tails and fades you hear the grain the format is known for. It comes after the saturation, so driving the output knob never pushes it into harsh clipping while saturation is on.
Turn 12 BIT off when you want the filter's character without any reduction, for example on a full mix or a mastering bus.
The noise floor
Every analog machine hisses a little. LH-2044 adds a quiet broadband hiss at about -75 dBFS, modelled on the clock and power-supply bleed measured at the output of a real SP-1200. It is added last, after the 12-bit stage and outside the filter, so the cut-off never dulls it. In stereo each side gets its own hiss, so it sits around the sound rather than in the middle; with MONO lit both sides get the same hiss.
The hiss is there even when the input is silent, so an LH-2044 on a silent track still makes a very quiet sound. It is on by default and, like saturation, switched from your host through the Noise parameter. When it is off, nothing at all is added.
Host-only switches
Two parameters have no control on the faceplate. Every host can still reach them: in its generic parameter view (often a button that switches the plugin window to a list of sliders), in its automation lanes, or by mapping them to a controller.
| Parameter | Default | Off means |
|---|---|---|
| Saturation | On | No output op-amp: a clean, linear output stage. |
| Noise | On | No hiss: digital silence when the input is silent. |
Both are saved with your session like every other parameter.