Skip to content

Parameter Reference

All ten parameters on one page, with the names your host shows, their ranges and their defaults.

Knobs

Host nameRangeDefaultNotes
Cutoff20 Hz to 20 kHz500.0 HzKnob travel favours low and middle frequencies. Smoothed over 20 ms. Limited to just under half the sample rate.
Resonance1.0 to 20.03.2Never self-oscillates. Smoothed over 20 ms.
AttackOFF, 1 to 100100Envelope amount: at 100 a hit opens the filter by up to six octaves. Smoothed over 20 ms.
Threshold-80 dB to -10 dB-35.0 dBFires the envelope when the input rises above it after 50 ms below it.
Output Level-48 dB to +12 dB0 dBGain into the saturation stage. No readout: the meter shows its effect.

Switches

Host nameFaceplateDefaultOn means
BypassOFF / ONOff (effect ON)Audio passes through untouched; the meter goes dark.
12bit12 BITOnOutput rounded to 12-bit resolution.
Mono SumMONOOffLeft and right summed (each at half level) before the filter.
SaturationNoneOnThe output op-amp's soft knee after the output level.
NoiseNoneOnA -75 dBFS analog hiss added last.

Fixed behaviour

These are part of LH-2044's design and have no control:

WhatValue
Filter slope4-pole low-pass, 24 dB per octave
Bass liftAbout +4 dB below 90 Hz
Makeup gainAbout +4 dB after the filter
Envelope rise5 ms
Envelope fallAbout 300 ms; cannot refire until it has finished
Envelope re-armInput must stay below the threshold for 50 ms
Saturation onsetAbout -7 dBFS; output stays just below full scale
LatencyNone